Linux for MIPS microAptiv uP

Home Forums MIPS Insider Linux for MIPS microAptiv uP

This topic contains 2 replies, has 2 voices, and was last updated by  alastair 2 years, 4 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #64064



    I wanted to know if I could get any information regarding any attempt to support linux for the Samsung Artik 1 hardware

    Can you guide me in the right direction.




    That chip seems to be a microAptiv with an MMU, so it should be possible to run Linux on there.

    The configuration will be similar to a pic32MZ so you could adapt a pic32mz build for the artik 1. However the hard part might be getting the chip to boot and load Linux.



    Thanks alastair, I was thinking along the same lines. But I was unable to find a yocto/buildroot configuration for PIC32MZ. The only port that I came across was of LiteBSD to PIC32MZ:

    If I could get a yocto/buildroot config for PIC32MZ, I think I can work with that.


Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.