Kaushal

Forum Replies Created

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • in reply to: Connecting to OpenOCD busblaster over Ethernet? #64388

    Kaushal
    Participant

    Is this true for Codescape console as well? Because in the first reply you had mentioned Codescape console can discover Busblaster over network using discoverprobe() call.

    Thanks
    Kaushal

    in reply to: Connecting to OpenOCD busblaster over Ethernet? #64390

    Kaushal
    Participant

    Further to my previous e-mail, using mips_busblaster.cfg file, I am able to detect the Busblaster probe and Openocd is able to get ID codes from the JTAG chain.

    Kaushal

    in reply to: Connecting to OpenOCD busblaster over Ethernet? #64391

    Kaushal
    Participant

    Can you please confirm Openocd configuration file(s) to be used for setting up Openocd + Codescape over network? Currently, I am invoking Openocd using

    openocd -f mips_busblaster.cfg

    Are there any extra configuration file(s) and command line options to be used?

    Thanks
    Kaushal

    in reply to: Connecting to OpenOCD busblaster over Ethernet? #64393

    Kaushal
    Participant

    I am running Openocd on Linux. The drivers are installed and I can debug using Openocd commands in Linux. So I don’t see any issue with the hardware. I can even do telnet to Openocd from remote PC and debug.

    Can you tell me how exactly Codescape discovers Busblaster over the network so that I can check if there are any network issues. As I said, I am able to connect to Openocd remotely over network.

    Thanks
    Kaushal

    in reply to: Connecting to OpenOCD busblaster over Ethernet? #64395

    Kaushal
    Participant

    I have tried Add target option. But BusBlaster does not show up over the network. Hence I was asking if there any way to manually set IP address and port. Or if you can tell me the default port it searches, I can start Openocd with that port.

    Thanks
    Kaushal

    in reply to: Connecting to OpenOCD busblaster over Ethernet? #64397

    Kaushal
    Participant

    I have tried steps mentioned in the startup guide but Codescape and unable to detect BusBlaster. As I mentioned, Busblaster is on the same subnet as Codescape PC.

    Is there a way I can manually give the IP address and port number in Codescape?

    Thanks
    Kaushal

    in reply to: Connecting to OpenOCD busblaster over Ethernet? #64399

    Kaushal
    Participant

    I have downloaded Openocd 0.10.0.3 from Imagination website and have a license for Codescape Debugger GUI version 8.5.6. Can you please confirm if this is the correct way of setting up Openocd and Codescape?

    1) Run Openocd on PC where the Busblaster is connect via USB
    openocd -f mips_busblaster.cfg

    2) Run DAConfig GUI on another PC and add DA-net target. Both PCs are on same subnet. DA-net fails to find Busblaster. It then asks for specific IP address. I added the IP address of PC on which Openocd is running but it still fails to find Busblaster.

    Does it require a specific port number? I think Openocd open port 4444 by default.

    Thanks
    Kaushal

Viewing 7 posts - 1 through 7 (of 7 total)